I put the switchutility box on mine so I wouldnt have to worry about arcing wearing out the contacts on the toggle switch on the motor-its a lot easier and cheaper to change a wall switch.
Delta Band Saw Serial Number And AI didnt grab a picture of the model number, but I do have a serial number and a couple quick snapshots.It is in working condition, but just curious on the quality of this older machine If I were to buy a new one, would this older unit be comparable to a low end unit, middle of the road or higher end saw Thank you. I have a speed reduction gear box on it and usually use it for steel and aluminum. I added the accessory 6 riser kit right after I got it so that I could re-saw 10 wide wood for guitar backs and sides. Mine has a 12 hp Baldor motor which is plenty for what I do with the unit. In all the time that Ive used mine, which is literally many hundreds of hours, the only maintenance has been a set of bearings for the motor, a set of ball bearings for the guides and a couple of sets of belts for the wheels. I use 34 by 34 skip-tooth blades for heavy work and its always made beautiful cuts. If I were you, Id be over at the school scooping that one up pronto. I dont know what the new ones are like, but the vintage Delta items are hard to beat. Might want to look around the OWWM site, more than enuf info there. The only aftermarket piece I see is that wood guide that you can see now that Ive taken the guards off. Any idea why that was installed Was there something there prior to this add on or is this just simply a safety precaution in case the blade brakes Thank you. When I added the riser kit, that also had a longer wooden guard. By the way, I tried cutting thin aluminum sheet with my saw a couple of times, but chips got embedded in the rubber belts, so I just stuck to wood only. The gear box and several other less significant parts were changed over the years. Take a photo of the gear box and actuation knob lever for better info on the model. Here is an image of the gear box, I spun the lower wheels (where the belt is attached)but those two pulleys is the only thing that moved, the blade did not move. Im not certain if a belt is missing or if something else needs to engage once the motor starts. Ive not powered it on due to not having easy access to 220 at this time. Sorry about the fuzzy close up of the plate but its the best my camera will do. Delta Manufacturing Co. Publication Reprints VintageMachinery.org OWWM is the absolute best place to ask about old Delta machines, those guys are deeply into that stuff.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |